1, the plastic bottle cap mold installation test
The test model is a very important content in the production process, and its change is the supplement to the design.
2, ready to do activities
Positive testing of plastic bottle caps and related equipment before testing. To analyze the closed it is not reasonable to view the provisions of the relevant size and equipment and the form is not able to maintain consistency, to analyze the plastic cap mould parts in the pores is not reasonable, there is no card slot problem. To ensure that its activities are very flexible, and good stability, to ensure the positioning precision of the azimuth. All embedded parts should be fixed, to avoid the occurrence of loose. All pipe joints and valves must be fully configured, and to the direction of the detection of injection, water and other lines and other parts of the analysis, in order to ensure its operation is reasonable.
3, on the installation and testing
(1) its installation shall be in accordance with the provisions of the drawings.
(2) the plastic bottle cap mould should be consistent with the horizontal plane when it slides.
(3) if there is a big difference between the size and the width, make sure that the longer one is the same as the horizontal one.
(4) if the existing oil and some other line joints, should be put in the inactive side, to prevent activities when the adverse phenomenon, usually in the injection machine in the regulation is the use of screw. Generally with four to eight of the pressure plate, and to set the symmetry.
Will it put in an injection device, to its regulation, its meaning is to analyze all the sports equipment in the plastic cap mould is not stable, the original position is not able to play due to the specific benefits, concerned about the following matters.
(1) to ensure that the plastic bottle cap mold parting surface can not exist between the pores, there must be a very large force to ensure that their effective gathering.
(2) to ensure that the oblique push rod and some other parts of the movement is stable, there is no interference problems, and positioning to be precise and reasonable.
(3) in the mold, to ensure that the launch of the product is stable, the plastic parts and pouring system in the material of plastic bottle mold, otherwise it will have a negative impact on.
(4) to ensure that the cooling water is smooth, prevent leakage problems, to ensure that all valves operate in an orderly manner.
4, test mode
Do a good job after the installation adjustment activities can be tested. Specifically, we should first put into raw materials, and then adjust the relevant value of the machine.
5, inspection
To detect the plastic bottle cap mold design is not accurate, the sample is not the same as the provisions of the use of people. Plastic bottle mold is not able to mass production. At this time may occur adverse phenomena, to actively adjust the treatment to ensure compliance with the provisions of the user.
